Parasound JC 2 Bedienungsanleitung PDF herunterladen (Seite 8)

CONNECTING YOUR JC 2 continued

OUTPUT CONNECTIONS

There are four pairs of output connections on the JC 2. All of them are active simultaneously.

Record Out Jacks

The Record Out jacks connect to the

Record Input jacks on your audio

recorder. The Record Out jacks provide

ﬁxed level signals that are unaffected

by the master volume control, L or R

level trim controls, mute or polarity

invert select.

Note: The Record Out jacks of the JC 2

are not switched as a monitor

for simultaneous comparisons of

recording to source.

Main Output Jacks

The Main Output Jacks are the primary

outputs that connect to the inputs on

your ampliﬁer(s). There are both

balanced and unbalanced Main Out

jacks. If your ampliﬁer is equipped with

balanced inputs we recommend this

type of connection. The polarity of the

Main Outputs is the same as the input,

but can be inverted 180° by pressing the

Invert button on the JC 2’s remote control. When polarity is inverted the POLARITY INVERT

indicator will illuminate on the front panel. For more information on when to use the polarity

invert feature please see the Frequently Asked Questions section of this manual.

Note: The JC 2 uses a fully differential balanced circuit and its balanced outputs do not require

or use phase inverters.

Inverted Out Jacks

The polarity at the Inverted Out jacks is always 180° from the input signal, and is not affected

by the Invert button on the remote. You may use the inverted output jacks to maintain correct

absolute polarity if your power ampliﬁer(s) invert polarity. For more information on absolute

polarity please see the Frequently Asked Questions section of this manual.

Inverted Out Jacks and Power Ampliﬁer Bridging

You can bridge a conventional two channel power ampliﬁer to mono by connecting one ampliﬁer

input channel to the JC 2’s left channel Inverted Out jack and the other ampliﬁer input channel to

the JC 2’s right channel Main Out jack. Connect a single mono speaker to the ampliﬁer’s left and

right positive (+) terminals, with no wires connected to its negative (–) terminals.

Note: While this won’t hurt the JC 2, you can seriously damage the power ampliﬁer if you make

any connections to its negative (–) speaker terminals.

Connecting a Signal Processor to Your JC 2

You can patch a signal processor between the JC 2 and your power ampliﬁer(s). This would

include devices such as an electronic crossover or the equalizer that is supplied with a particular

speaker. Make sure that the signal processor’s input can accept the full output of the JC 2

without overloading. You should also adjust the gain controls of your ampliﬁer, processor, and

the JC 2 for the lowest noise level.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Parasound JC 2 Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern